Solar Lattice

Fault codes › CPS › CPS SCH100/125KTL-DO/US-600

CPS SCH100-125KTL PV Over current

Code
PV Over current
Shown as
PV over current
Vendor severity
Protection
Page
77
ID
fc:chint-sch-100-125ktl-pvovercurrent
IRI
https://solarlattice.org/kb/fc/chint-sch-100-125ktl-pvovercurrent
Status
active
Also known as
PV Over current, pvovercurrent, CPS PV Over current, PV over current
Category
Inverters
Class fault drafted · lead
Production not stated
Clears after a manual reset drafted · lead

Decoded

Reports DC overcurrent; confirm with PV input current measurement; do: inverter restart, inverter replacement.

What can be behind DC overcurrent

Failure modes that present as the reported condition, and the tests that tell them apart.

Defined in

The manufacturer's own cause and corrective text is not reproduced here.

Same condition on other equipment

ABB / FIMER
ABB / FIMER PVS-166-175-TL E001, ABB / FIMER PVS-60-TL E001, ABB / FIMER TRIO-20.0-27.6-TL E001, ABB / FIMER UNO-DM-3.3-5.0-PLUS E001, ABB / FIMER UNO-DM-6.0-PLUS E001
CPS
CPS SCA25KTL-208 PVx Over current, CPS SCA36KTL PVx Over current, CPS SCA50-100K-T Fault4030, CPS SCA50-100K-T PFault0050, CPS SCA50-100K-T Protect0360, CPS SCA50-100K-T Protect0060, CPS SCA50-100K-T Protect0820, CPS SCA50-100K-T Protect0850, CPS SCA50-100K-T Protect0880, CPS SCA50-60KTL PVx Over current, CPS SCH125KTL-AIO PV Over current
Canadian Solar
Canadian Solar 185-255K DC-INTF, Canadian Solar 185-255K OV-DCA-I
Fronius
Fronius Galvo 302, Fronius Primo 302, Fronius Symo 302
SMA
SMA SB-US-40 3801, SMA SB-US-41 3801, SMA SB-US-41 3802, SMA SB-US-41 3805, SMA CORE1-US 3801, SMA CORE1-US 3802, SMA CORE1-US 3803, SMA CORE1-US 3805, SMA CORE1-US 3806, SMA CORE1-US 3807, SMA CORE1-US 3808, SMA STP-TL-US 3801-3802, SMA STP-X-US 6406, SMA STP-X-US 6407, SMA SC-CP-XT 3803
Schneider Electric
Schneider Electric CL125 021, Schneider Electric CL125 040
Solis
Solis 3P-5G-US DC-INTF, Solis 3P-5G-US OV-DCA-I, Solis RHI-1P-HV DC-INTF, Solis RHI-1P-HV OV-DCA-I, Solis S6-EH1P DC-INTF, Solis S6-EH1P OV-DCA-I, Solis S6-EH2P DC-INTF, Solis S6-EH2P OV-DCA-I, Solis S6-EH2P OV-DCB-I, Solis S6-EH3P30-60K DC-INTF, Solis S6-EH3P30-60K OV-DCA-I, Solis S6-EH3P30-60K OV-DCB-I, Solis S6-EH3P75-150K DC-INTF, Solis S6-EH3P75-150K OV-DCA-I, Solis S6-EH3P75-150K OV-DCB-I, Solis S6-GC DC-INTF, Solis S6-GC OV-DCA-I, Solis S6-GC OV-DCB-I, Solis S6-GU DC-INTF, Solis S6-GU OV-DCA-I, Solis S6-GU OV-DCB-I

Same code in other families

Claims

defined_in

c1 drafted · lead CPS SCH100-125KTL-DO-US-600-480 User Manual Rev 1.9

has_event_class

c2 drafted · lead Fault (device stops or needs intervention)

from the table header

reports

c3 drafted · lead DC overcurrent

detected_by

c4 drafted · lead PV input current measurement

review note: support check: partial - Passages say to check PV input current but do not state it is detected by PV current measurement.

has_recovery

c5 drafted · lead Manual reset (operator restarts or acknowledges)

Check PV current and power cycle; replace the inverter if the fault cannot be cleared

mitigated_by

c6 drafted · lead Inverter restart

c7 drafted · lead Inverter replacement

applies_to

c8 drafted · lead CPS SCH100-125KTL-DO/US-600

Data