Solar Lattice

Fault codes › Fronius › Fronius Symo UL (10.0-3 to 24.0-3 208-240/480)

Fronius Symo 608

Code
608
Vendor severity
Class 6
ID
fc:fronius-symo-608
IRI
https://solarlattice.org/kb/fc/fronius-symo-608
Status
active
Also known as
608, Fronius 608
Category
Inverters
Class fault drafted · lead
Production stops drafted · lead
Clears not stated

Decoded

Reports hardware component incompatibility; do: firmware update.

What can be behind Hardware component incompatibility

Failure modes that present as the reported condition, and the tests that tell them apart.

Defined in

The manufacturer's own cause and corrective text is not reproduced here.

Same condition on other equipment

Fronius
Fronius Galvo 445, Fronius Galvo 558, Fronius Primo 417, Fronius Primo 436, Fronius Primo 438, Fronius Primo 445, Fronius Primo 480, Fronius Primo 481, Fronius Primo 558, Fronius Symo 417, Fronius Symo 436, Fronius Symo 438, Fronius Symo 445, Fronius Symo 480, Fronius Symo 481, Fronius Symo 558, Fronius Symo 559, Fronius Symo 564
Generac
Generac PWRcell Inverter 0X7700, Generac PWRcell Inverter 0X7703, Generac PWRcell Inverter 0X7707

Claims

defined_in

c1 drafted · lead fronius-symo-ul-emanual-status-codes

reports

c2 drafted · lead Hardware component incompatibility

Circuit boards do not match, for example after a board replacement.

has_event_class

c3 drafted · lead Fault (device stops or needs intervention)

has_production_effect

c4 drafted · lead Trip (production stops)

mitigated_by

c5 drafted · lead Firmware update

Contact a trained service technician if the code persists after the update.

review note: support check: partial - The firmware update remedy is stated, but the passage for 608 does not say to contact a technician if the…

applies_to

c6 drafted · lead Fronius Symo

Data