Solar Lattice

Fault codes › Fronius › Fronius Primo 208-240 (3.8-1 to 15.0-1)

Fronius Primo 417

Code
417
Shown as
ID problem with hardware
Vendor severity
Class 4
ID
fc:fronius-primo-417
IRI
https://solarlattice.org/kb/fc/fronius-primo-417
Status
active
Also known as
417, Fronius 417, ID problem with hardware
Category
Inverters
Class fault drafted · lead
Production stops drafted · lead
Clears by itself drafted · lead

Decoded

Reports hardware component incompatibility; do: firmware update, contact manufacturer service.

What can be behind Hardware component incompatibility

Failure modes that present as the reported condition, and the tests that tell them apart.

Defined in

The manufacturer's own cause and corrective text is not reproduced here.

Same condition on other equipment

Fronius
Fronius Galvo 445, Fronius Galvo 558, Fronius Primo 436, Fronius Primo 438, Fronius Primo 445, Fronius Primo 480, Fronius Primo 481, Fronius Primo 558, Fronius Symo 417, Fronius Symo 436, Fronius Symo 438, Fronius Symo 445, Fronius Symo 480, Fronius Symo 481, Fronius Symo 558, Fronius Symo 559, Fronius Symo 564, Fronius Symo 608
Generac
Generac PWRcell Inverter 0X7700, Generac PWRcell Inverter 0X7703, Generac PWRcell Inverter 0X7707

Same code in other families

Claims

defined_in

c1 drafted · lead fronius-primo-208-240-emanual-status-codes

reports

c2 drafted · lead Hardware component incompatibility

review note: support check: partial - 417 is an 'ID problem with hardware', which roughly matches hardware incompatibility but is not stated as incompatibility.

has_event_class

c3 drafted · lead Fault (device stops or needs intervention)

review note: support check: partial - The row shows auto-retry and firmware update remedy, but no explicit fault classification.

has_production_effect

c4 drafted · lead Trip (production stops)

review note: support check: partial - Reconnect and 'resume' feed implies interruption, but it is not explicitly stated.

has_recovery

c5 drafted · lead Auto-reset (clears by itself)

Firmware update, then service technician if it persists.

mitigated_by

c6 drafted · lead Firmware update

c7 drafted · lead Contact manufacturer service

Only when the code persists after firmware update.

applies_to

c8 drafted · lead Fronius Primo 208-240

Data