Solar Lattice

Fault codes › CPS › CPS SCA100K-T-US-480 / SCA50K-T-US-208

CPS SCA50-100K-T Fault2000-2150

Code: Fault2000-2150
Shown as: PV1 …PV16 ReverseInject Fault
Vendor severity: Fault
Page: 145
ID: fc:chint-sca-50-100k-t-fault2000-2150
IRI: https://solarlattice.org/kb/fc/chint-sca-50-100k-t-fault2000-2150
Status: active
Also known as: Fault2000-2150, fault2000-2150, CPS Fault2000-2150, PV1 …PV16 ReverseInject Fault
Category: Inverters

Class fault drafted · lead

Production stops drafted · lead

Clears after a manual reset drafted · lead

Decoded

Reports string reverse current; look at PV array; confirm with string current measurement; do: string isolation, string configuration correction, inverter restart, contact manufacturer service.

What can be behind String reverse current

Failure modes that present as the reported condition, and the tests that tell them apart.

DC string miswiring drafted · lead

Defined in

CPS SCA100K-T-US-480 SCA50K-T-US-208 User Manual Rev 1.0 — CPS (Chint Power Systems) · page 145 drafted · lead
- tbl=63.r1 h=f481151258c7

The manufacturer's own cause and corrective text is not reproduced here.

Same condition on other equipment

ABB / FIMER: ABB / FIMER PVS-166-175-TL E084, ABB / FIMER PVS-60-TL E084, ABB / FIMER UNO-DM-3.3-5.0-PLUS E084, ABB / FIMER UNO-DM-6.0-PLUS E084
CPS: CPS SCA50-100K-T Fault3000-3070
Huawei: Huawei SUN2000-100KTL-USH0 2012
SMA: SMA SBSE-US-50 4013, SMA SBSE-US-50 4014, SMA SBSE-US-50 4015, SMA SBSE-US-50 4016, SMA SBSE-US-50 4017, SMA SC-CP-XT 4003, SMA SC-CP-XT 7901
Sungrow: Sungrow SG200HX 1548-1579, Sungrow SG250HX 1548-1579, Sungrow SG350HX 1548-1579

Claims

`defined_in`

c1 drafted · lead CPS SCA100K-T-US-480 SCA50K-T-US-208 User Manual Rev 1.0

CPS SCA100K-T-US-480 SCA50K-T-US-208 User Manual Rev 1.0 tbl=63.r1 h=f481151258c7

`has_event_class`

c2 drafted · lead Fault (device stops or needs intervention)

from the code prefix

CPS SCA100K-T-US-480 SCA50K-T-US-208 User Manual Rev 1.0 tbl=63.r1 h=f481151258c7

`reports`

c3 drafted · lead String reverse current

CPS SCA100K-T-US-480 SCA50K-T-US-208 User Manual Rev 1.0 tbl=63.r1 h=f481151258c7

`affects`

c4 drafted · lead PV array

CPS SCA100K-T-US-480 SCA50K-T-US-208 User Manual Rev 1.0 tbl=63.r1 h=f481151258c7

`detected_by`

c5 drafted · lead String current measurement

CPS SCA100K-T-US-480 SCA50K-T-US-208 User Manual Rev 1.0 tbl=63.r1 h=f481151258c7

review note: support check: partial - Row says use a meter to find the abnormal string, but does not say it measures string current.

`mitigated_by`

c6 drafted · lead String isolation

CPS SCA100K-T-US-480 SCA50K-T-US-208 User Manual Rev 1.0 tbl=63.r1 h=f481151258c7

c7 drafted · lead String configuration correction

CPS SCA100K-T-US-480 SCA50K-T-US-208 User Manual Rev 1.0 tbl=63.r1 h=f481151258c7

c8 drafted · lead Inverter restart

CPS SCA100K-T-US-480 SCA50K-T-US-208 User Manual Rev 1.0 tbl=63.r1 h=f481151258c7

c9 drafted · lead Contact manufacturer service

CPS SCA100K-T-US-480 SCA50K-T-US-208 User Manual Rev 1.0 tbl=63.r1 h=f481151258c7

`has_production_effect`

c10 drafted · lead Trip (production stops)

Protection fault; restart required after the alarm clears implies the inverter stopped.

CPS SCA100K-T-US-480 SCA50K-T-US-208 User Manual Rev 1.0 tbl=63.r1 h=f481151258c7
CPS SCA100K-T-US-480 SCA50K-T-US-208 User Manual Rev 1.0 tbl=48 h=9cff980c7e47

review note: support check: partial - Restart is required after the fault, implying a stop, but a trip is not explicitly stated for this row.

`has_recovery`

c11 drafted · lead Manual reset (operator restarts or acknowledges)

Wait for alarm to clear, then switch cycle and restart; if persistent, isolate and fix strings, then service.

CPS SCA100K-T-US-480 SCA50K-T-US-208 User Manual Rev 1.0 tbl=63.r1 h=f481151258c7

`applies_to`

c12 drafted · lead CPS SCA100K-T-US-480 / SCA50K-T-US-208

CPS SCA100K-T-US-480 SCA50K-T-US-208 User Manual Rev 1.0 tbl=63.r1 h=f481151258c7

Data