Solar Lattice

Fault codes › Yaskawa Solectria › Solectria PVI 20/25TL-480-R

Yaskawa Solectria PVI-25TL-R Protect0180

Code
Protect0180
Shown as
The sampling offset of DCI
Vendor severity
Protection
Page
81
ID
fc:yaskawa-solectria-pvi-20-25tl-480-r-protect180
IRI
https://solarlattice.org/kb/fc/yaskawa-solectria-pvi-20-25tl-480-r-protect180
Status
active
Also known as
Protect0180, protect180, Yaskawa Solectria Protect0180, The sampling offset of DCI
Category
Inverters
Class fault drafted · lead
Production not stated
Clears not stated

Decoded

Reports DC injection monitoring error; look at current sensor; do: sensor recalibration, inverter replacement.

What can be behind DC injection monitoring error

Failure modes that present as the reported condition, and the tests that tell them apart.

Defined in

The manufacturer's own cause and corrective text is not reproduced here.

Same condition on other equipment

Fronius
Fronius Primo 462, Fronius Symo 462

Claims

defined_in

c1 drafted · lead PVI 20-25TL-480-R IOM DOCR-071030-A

has_event_class

c2 drafted · lead Fault (device stops or needs intervention)

from the code prefix

reports

c3 drafted · lead DC injection monitoring error

review note: support check: partial - The sampling offset of DCI is a DC injection sampling issue, but 'monitoring error' is a looser characterization.

affects

c4 drafted · lead Current sensor

review note: support check: partial - A sampling offset implies a sensor, but a current sensor is not named.

mitigated_by

c5 drafted · lead Sensor recalibration

Applies when the inverter can still start up.

c6 drafted · lead Inverter replacement

Only when the alarm persists and the inverter cannot start.

applies_to

c7 drafted · lead Solectria PVI 20/25TL-480-R

Data