Solar Lattice

Fault codes › Yaskawa Solectria › Solectria PVI 20/25TL-480-R

Yaskawa Solectria PVI-25TL-R Protect0100

Code
Protect0100
Shown as
The sensor fault of leakage current
Vendor severity
Protection
Page
82
ID
fc:yaskawa-solectria-pvi-20-25tl-480-r-protect100
IRI
https://solarlattice.org/kb/fc/yaskawa-solectria-pvi-20-25tl-480-r-protect100
Status
active
Also known as
Protect0100, protect100, Yaskawa Solectria Protect0100, The sensor fault of leakage current
Category
Inverters
Class fault drafted · lead
Production not stated
Clears after a manual reset drafted · lead

Decoded

May indicate current sensor fault; look at filter board; do: inverter restart, filter board replacement, inverter replacement.

Defined in

The manufacturer's own cause and corrective text is not reproduced here.

Claims

defined_in

c1 drafted · lead PVI 20-25TL-480-R IOM DOCR-071030-A

has_event_class

c2 drafted · lead Fault (device stops or needs intervention)

from the code prefix

indicates

c3 drafted · lead Current sensor fault

Leakage current sensor.

affects

c4 drafted · lead Filter board

mitigated_by

c5 drafted · lead Inverter restart

c6 drafted · lead Filter board replacement

If restart does not clear the fault.

c7 drafted · lead Inverter replacement

Alternative to filter board replacement if fault persists.

has_recovery

c8 drafted · lead Manual reset (operator restarts or acknowledges)

Power-cycle first; board or inverter replacement if fault persists.

review note: support check: partial - Power-cycle then replacement is stated, but clearing by manual reset is only implied.

applies_to

c9 drafted · lead Solectria PVI 20/25TL-480-R

Data