Solar Lattice

Fault codes › ABB / FIMER › UNO-DM-3.3/3.8/4.6/5.0-TL-PLUS-US

ABB / FIMER UNO-DM-3.3-5.0-PLUS E035

Code
E035
Shown as
Remote Off
Vendor severity
Error
Page
131
ID
fc:abb-uno-dm-3-3-5-0-plus-us-e35
IRI
https://solarlattice.org/kb/fc/abb-uno-dm-3-3-5-0-plus-us-e35
Status
active
Also known as
E035, e35, ABB / FIMER E035, Remote Off
Category
Inverters
Class fault drafted · lead
Production stops drafted · lead
Clears after a manual reset drafted · lead

Decoded

Reports remote shutdown; do: inverter restart.

What can be behind Remote shutdown

Failure modes that present as the reported condition, and the tests that tell them apart.

Defined in

The manufacturer's own cause and corrective text is not reproduced here.

Same condition on other equipment

ABB / FIMER
ABB / FIMER PVS-166-175-TL E035, ABB / FIMER PVS-60-TL E035, ABB / FIMER TRIO-20.0-27.6-TL E035, ABB / FIMER UNO-DM-6.0-PLUS E035
SMA
SMA CORE1-US 10513, SMA SC-CP-XT 9013, SMA SI-US E130
Yaskawa Solectria
Yaskawa Solectria SGI-XTM Power Disabled, Yaskawa Solectria SGI-XTM Shunt Trip, Yaskawa Solectria SGI-XTM Soft Shutdown

Same code in other families

Claims

defined_in

c1 drafted · lead FIMER UNO-DM-3.3-5.0-TL-PLUS-US-Q Product Manual RevB

c2 drafted · lead UNO-DM-3.3-5.0-TL-PLUS-US Product Manual RevA

has_event_class

c3 drafted · lead Fault (device stops or needs intervention)

from the code prefix

reports

c4 drafted · lead Remote shutdown

has_production_effect

c5 drafted · lead Trip (production stops)

review note: support check: partial - Inverter is switched off remotely and waiting, implying production stops, but 'trip' is not stated explicitly.

has_recovery

c6 drafted · lead Manual reset (operator restarts or acknowledges)

Remote ON command first; then full power cycle; then contact service

mitigated_by

c7 drafted · lead Inverter restart

applies_to

c8 drafted · lead UNO-DM-3.3/3.8/4.6/5.0-TL-PLUS-US string inverter

Data