Solar Lattice

Fault codes › ABB / FIMER › UNO-DM-3.3/3.8/4.6/5.0-TL-PLUS-US

ABB / FIMER UNO-DM-3.3-5.0-PLUS E011

Code
E011
Shown as
Ramp Fail
Vendor severity
Error
Page
129
ID
fc:abb-uno-dm-3-3-5-0-plus-us-e11
IRI
https://solarlattice.org/kb/fc/abb-uno-dm-3-3-5-0-plus-us-e11
Status
active
Also known as
E011, e11, ABB / FIMER E011, Ramp Fail
Category
Inverters
Class fault drafted · lead
Production not stated
Clears after a manual reset drafted · lead

Decoded

Reports boost converter startup timeout; look at DC boost converter; do: inverter restart.

What can be behind Boost converter startup timeout

Failure modes that present as the reported condition, and the tests that tell them apart.

Defined in

The manufacturer's own cause and corrective text is not reproduced here.

Same condition on other equipment

ABB / FIMER
ABB / FIMER PVS-166-175-TL E011, ABB / FIMER PVS-60-TL E011, ABB / FIMER TRIO-20.0-27.6-TL E011, ABB / FIMER UNO-DM-6.0-PLUS E011

Same code in other families

Claims

defined_in

c1 drafted · lead FIMER UNO-DM-3.3-5.0-TL-PLUS-US-Q Product Manual RevB

c2 drafted · lead UNO-DM-3.3-5.0-TL-PLUS-US Product Manual RevA

has_event_class

c3 drafted · lead Fault (device stops or needs intervention)

from the code prefix

reports

c4 drafted · lead Boost converter startup timeout

affects

c5 drafted · lead DC boost converter

mitigated_by

c6 drafted · lead Inverter restart

has_recovery

c7 drafted · lead Manual reset (operator restarts or acknowledges)

Power cycle first; contact service if the error persists.

review note: support check: partial - Power cycle then contact service is stated, but the passages never say the error clears by manual reset.

applies_to

c8 drafted · lead UNO-DM-3.3/3.8/4.6/5.0-TL-PLUS-US string inverter

Data