Solar Lattice

Fault codes › ABB / FIMER › FIMER PVS-166/175-TL-US

ABB / FIMER PVS-166-175-TL E026

Code
E026
Shown as
Internal error
Vendor severity
Error
Page
142
ID
fc:abb-pvs-166-175-tl-us-e26
IRI
https://solarlattice.org/kb/fc/abb-pvs-166-175-tl-us-e26
Status
active
Also known as
E026, e26, ABB / FIMER E026, Internal error
Category
Inverters
Class fault drafted · lead
Production not stated
Clears after a manual reset drafted · lead

Decoded

Reports reference voltage out of tolerance; look at inverter; do: inverter restart, contact manufacturer service.

What can be behind Reference voltage out of tolerance

Failure modes that present as the reported condition, and the tests that tell them apart.

Defined in

The manufacturer's own cause and corrective text is not reproduced here.

Same condition on other equipment

ABB / FIMER
ABB / FIMER PVS-60-TL E026, ABB / FIMER TRIO-20.0-27.6-TL E026, ABB / FIMER UNO-DM-3.3-5.0-PLUS E026, ABB / FIMER UNO-DM-6.0-PLUS E026
Fronius
Fronius Galvo 460, Fronius Primo 460, Fronius Symo 460
KACO new energy
KACO new energy blueplanet TL3 150

Same code in other families

Claims

defined_in

c1 drafted · lead FIMER PVS-166-175-TL-US A.2 Product Manual RevE

has_event_class

c2 drafted · lead Fault (device stops or needs intervention)

from the code prefix

reports

c3 drafted · lead Reference voltage out of tolerance

affects

c4 verified · fact Inverter

verified by: review-workflowverified on: 2026-10-23

mitigated_by

c5 drafted · lead Inverter restart

c6 drafted · lead Contact manufacturer service

has_recovery

c7 drafted · lead Manual reset (operator restarts or acknowledges)

Power cycle first; contact service if the fault persists afterwards.

review note: support check: partial - Power cycle then contact service is stated, but the passages never say the fault clears by manual reset.

applies_to

c8 drafted · lead FIMER PVS-166/175-TL-US string inverter

Data