Solar Lattice

Fault codes › Yaskawa Solectria › Yaskawa Solectria XGI 1500-DCG

Yaskawa Solectria XGI-1500-DCG CRIT-1

Code
CRIT-1
Shown as
Software Parameter Load Failure
Vendor severity
Critical
Page
54
ID
fc:yaskawa-solectria-xgi-1500-dcg-crit1
IRI
https://solarlattice.org/kb/fc/yaskawa-solectria-xgi-1500-dcg-crit1
Status
active
Also known as
CRIT-1, crit1, Yaskawa Solectria CRIT-1, Software Parameter Load Failure
Category
Inverters
Class fault drafted · lead
Production not stated
Clears after a manual reset drafted · lead

Decoded

Reports parameter download failure; do: firmware update, inverter restart.

What can be behind Parameter download failure

Failure modes that present as the reported condition, and the tests that tell them apart.

Defined in

The manufacturer's own cause and corrective text is not reproduced here.

Same condition on other equipment

SMA
SMA PEAK3-US 7102, SMA CORE1-US 7102, SMA STP-TL-US 7102
Yaskawa Solectria
Yaskawa Solectria XGI-1500-1MW CRIT-1, Yaskawa Solectria XGI-1500 CRIT-1

Same code in other families

Claims

defined_in

c1 drafted · lead XGI 1500 250 DCG IOM DOCR-071081-DD

has_event_class

c2 drafted · lead Fault (device stops or needs intervention)

from the table header

reports

c3 drafted · lead Parameter download failure

mitigated_by

c4 drafted · lead Firmware update

c5 drafted · lead Inverter restart

has_recovery

c6 drafted · lead Manual reset (operator restarts or acknowledges)

Firmware update and power cycle first; technical support if it persists.

review note: support check: partial - Power cycle/firmware update then contact support is stated, but that it clears by manual reset is only implied, not stated.

applies_to

c7 drafted · lead Solectria XGI 1500-DCG

Data