Solar Lattice

Fault codes › CPS › CPS SCH100/125KTL-DO/US-600

CPS SCH100-125KTL Fault0080

Code
Fault0080
Shown as
bus hardware over current fault
Vendor severity
Fault
Page
77
ID
fc:chint-sch-100-125ktl-fault80
IRI
https://solarlattice.org/kb/fc/chint-sch-100-125ktl-fault80
Status
active
Also known as
Fault0080, fault80, CPS Fault0080, bus hardware over current fault
Category
Inverters
Class fault drafted · lead
Production not stated
Clears after a manual reset drafted · lead

Decoded

Reports internal overcurrent or overvoltage; look at inverter; do: inverter restart, inverter replacement.

What can be behind Internal overcurrent or overvoltage

Failure modes that present as the reported condition, and the tests that tell them apart.

Defined in

The manufacturer's own cause and corrective text is not reproduced here.

Same condition on other equipment

CPS
CPS SCA25KTL-208 Fault0080, CPS SCA50-100K-T Protect0710, CPS SCH125KTL-AIO Fault0080, CPS SCH200-250K-T Fault0300
KACO new energy
KACO new energy blueplanet TL3 195
Schneider Electric
Schneider Electric CL125 051
Solis
Solis RHI-1P-HV OV-ILLC, Solis S6-EH1P OV-ILLC, Solis S6-EH2P OV-ILLC, Solis S6-EH3P30-60K OV-ILLC, Solis S6-EH3P75-150K OV-ILLC
Yaskawa Solectria
Yaskawa Solectria XGI-1500-1MW WARN-1, Yaskawa Solectria XGI-1500-DCG WARN-1, Yaskawa Solectria XGI-1500 WARN-1

Same code in other families

Claims

defined_in

c1 drafted · lead CPS SCH100-125KTL-DO-US-600-480 User Manual Rev 1.9

has_event_class

c2 drafted · lead Fault (device stops or needs intervention)

from the table header

reports

c3 drafted · lead Internal overcurrent or overvoltage

review note: support check: partial - Fault0080 is a bus hardware over current fault; overvoltage isn't mentioned, though the label covers overcurrent.

affects

c4 drafted · lead Inverter

mitigated_by

c5 drafted · lead Inverter restart

c6 drafted · lead Inverter replacement

Only if a power cycle does not clear the fault.

has_recovery

c7 drafted · lead Manual reset (operator restarts or acknowledges)

Power cycle first; replace inverter if the fault persists.

review note: support check: partial - Power cycle then replace is stated; manual-reset classification only implied.

applies_to

c8 drafted · lead CPS SCH100-125KTL-DO/US-600

Data