Solar Lattice

Fault codes › ABB / FIMER › UNO-DM-6.0-TL-PLUS-US

ABB / FIMER UNO-DM-6.0-PLUS E031

Code
E031
Shown as
Error Read V
Vendor severity
Error
Page
127
ID
fc:abb-uno-dm-6-0-plus-us-e31
IRI
https://solarlattice.org/kb/fc/abb-uno-dm-6-0-plus-us-e31
Status
active
Also known as
E031, e31, ABB / FIMER E031, Error Read V
Category
Inverters
Class fault drafted · lead
Production not stated
Clears after a manual reset drafted · lead

Decoded

Reports relay voltage mismatch; may indicate relay failure; look at grid tie relay; do: inverter restart, contact manufacturer service.

What can be behind Relay voltage mismatch

Failure modes that present as the reported condition, and the tests that tell them apart.

Defined in

The manufacturer's own cause and corrective text is not reproduced here.

Same condition on other equipment

ABB / FIMER
ABB / FIMER PVS-166-175-TL E031, ABB / FIMER PVS-60-TL E031, ABB / FIMER TRIO-20.0-27.6-TL E031, ABB / FIMER UNO-DM-3.3-5.0-PLUS E031
KACO new energy
KACO new energy blueplanet TL3 105

Same code in other families

Claims

defined_in

c1 drafted · lead FIMER UNO-DM-6.0-TL-PLUS-US-Q Product Manual RevB

c2 drafted · lead UNO-DM-6.0-TL-PLUS-US Product Manual RevA

has_event_class

c3 drafted · lead Fault (device stops or needs intervention)

from the code prefix

reports

c4 drafted · lead Relay voltage mismatch

indicates

c5 drafted · lead Relay failure

affects

c6 drafted · lead Grid tie relay

mitigated_by

c7 drafted · lead Inverter restart

c8 drafted · lead Contact manufacturer service

has_recovery

c9 drafted · lead Manual reset (operator restarts or acknowledges)

Power cycle first; contact service if it persists

review note: support check: partial - Power cycle then contact service is stated, but manual-reset clearing isn't.

applies_to

c10 drafted · lead UNO-DM-6.0-TL-PLUS-US string inverter

Data