SunSpec model 112 Inverter (Split Phase) FLOAT

SunSpec arranges device registers into defined groups called models, and each model starts with a header that identifies it and gives its length. A device reports which inverter model family it implements through the C_SunSpec_DID register, where 102 means split phase, 101 means single phase and 103 means three phase. SMA lists model 102 split phase AC monitoring as supported but recommends model 701 instead, because the 100 series is now marked as outdated in favour of the 700 series. Inverters support only the models and registers their vendor map lists, and unsupported registers are marked Reserved, so check the map before polling.

<!-- review notes

• sentence 4: support check: partial - Passage says only listed models and supported registers are supported, unsupported ones are Reserved, and to use only supported registers; 'check the map before polling' is advice implied but the claim is for a specific vendor (SOLECTRIA) generalized to inverters.
• sentence 4: review: partial - The passage covers only SOLECTRIA XGI 1500 inverters (listed models only, unsupported registers marked Reserved), so applying it to all inverters and their vendor maps widens the scope. -->